Fujitsu Eternus2000 Manual page 115

5
Disconnect the LAN cable (twist pair cable compatible with Category 5) (for oper-
ation management) from the PC, and connect the LAN cable (twist pair cable
compatible with Category 5) (for operation management) connected to the MNT
port of controller 0 (CM#0) and controller 1 (CM#1) to your network.
6
Start the web browser, log on again with the new IP address, and perform the
settings from Setting2 to Setting6.
4.3.1.2 Device Environment Settings (Setting2)
Set the device environment to start the device operation.
For details on the settings, refer to "ETERNUS2000 ETERNUSmgr User Guide -Settings/Maintenance-".
Refer
Procedure
1
Click the [STEP2] button in the [Tutorial] wizard.
Setting2: starting [Device environment settings] screen appears.
2
Click the [Execute] button.
A screen to set the device environment appears.
3
Set each item for device date and time and click the [Next >] button.
Figure 4.8
A screen to set the port (topology) appears.
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
"ETERNUS2000 ETERNUSmgr User Guide -Settings/Maintenance-"
Date and time setting screen
Copyright 2009 FUJITSU LIMITED
Chapter 4 Setup
4
91