Installable Drive Enclosures; Drive Enclosure Rack Mounting Procedure - Fujitsu Eternus2000 Manual

5.2 Drive Enclosure Installation
5.2.2

Installable Drive Enclosures

Refer to
At time of purchase, the drive enclosure model may be different from those described.
The latest manual is available via the following web-site, and should be referred to as necessary.
http://www.fujitsu.com/global/services/computing/storage/system/eternus2000/
5.2.3

Drive Enclosure Rack Mounting Procedure

This section describes how to mount a drive enclosure in a rack.
IMPORTANT
1
2
128
"A.2.2 Drive Enclosure" (page 171)
Do
CAUTION
• If drive enclosures are installed in a way other than by the methods
described herein, damage to the device and/or failure or electrical
shock may occur.
• Make sure to install the drive enclosures in order, above the controller
enclosure.
• Take care not to knock or drop the drive enclosure on the rack when
installing it.
• When no other components are to be installed in a drive slot, install the
dummy disk units provided with the rack.
• When expanding multiple drive enclosures, by installing them into
the rack or expanding by using settings or the maintenance pro-
gram, make sure to expand one by one.
• Do not install the miniSAS cable (for drive enclosures) or power
code when installing the drive enclosure in the rack. Connect them
in
Installation".
• Install the disk drive after expanding the drive enclosure.
Refer to "ETERNUS2000 models 100 and 200 disk storage system Package
Contents" and check that no rack mount kit components are missing.
Adjust the bracket sizes to fit the rack.
Reposition the M4 screws to adjust the length of the brackets to match the distance between the
front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the bracket must be
attached to the rack before they can be completely tightened.
for a list of drive enclosures that may be installed.
Step 7 and Step 8 in
ETERNUS2000 disk storage system User Guide
Copyright 2009 FUJITSU LIMITED
"5.2.4 Additional Drive Enclosure
P3AM-2512-03EN