Fujitsu Eternus2000 Manual page 102

4.2 Cable Connection
78
Do
CAUTION
• Be sure to fully insert each plug into its socket. Failure to do so
may lead to fire or electrical shock.
Do Not
• When disconnecting the power plug, be sure to pull from the
plug and not the cord. Pulling the cord may expose or snap the
inner wires, which can lead to fire or electrical shock.
• Do not use the server service outlet to connect the device
power cord.
• Do not overload an electrical outlet. Doing so may lead to elec-
tric shock or fire.
Unplug
• If the ETERNUS2000 is not going to be used for a long period
of time, it is advisable to unplug all power cords to avoid any
chance of fire to the ETERNUS2000 and its peripherals.
After unplugging the power cord, wait until the POWER STATUS
Point
LED of the power unit has turned off completely before reconnect-
ing it.
(It takes about ten seconds for the POWER STATUS LED to be
turned off completely.)
ETERNUS2000 disk storage system User Guide
Copyright 2009 FUJITSU LIMITED
P3AM-2512-03EN