Other Settings - Fujitsu Eternus2000 Manual

(from previous page)
4
Device Settings (Preparation)
Perform the device settings. Prepare and check the following items.
- Enter the IP Address and Subnet Mask into the Network Setting Label
- Attach the Network Settings sticker to the Rear Upper Central Label Plate
- Connect the PC and the ETERNUS2000 via LAN Cable (twisted pair cable compatible with Category 5)
- Network Setting for PC
- Web Browser Setting
- Power on the Device
5
Device Settings (Basic Settings)
Perform the basic settings with Tutorial in setting/maintenance program.
- Network Environment settings
- Device Environment Settings
- Hot Spare Disk Registration
- RAID Group Creation
- Volume Creation
- Host Affinity Group Creation
6

Other Settings

Perform the following settings (as required).
1
2
3
4
5
7
Operation and Troubleshooting
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Advanced Copy Setting
Register the AdvancedCopy license for the Advanced Copy function.
AC Auto Interlocking Mode
When setting the AC Auto Interlocking mode, turn on the AUTO POWER Switch of the
controller enclosure and drive enclosure.
Installing and Setting ETERNUSmgr
When monitoring the ETERNUS2000 using the ETERNUSmgr, install ETERNUSmgr on the management
server, and perform any required settings.
Settings for Maintenance
Perform the settings to simplify the maintenance (as required).
When connecting the device and PRIMERGY to use the server monitoring tool "ServerView",
perform the required settings for the SNMP Trap Transfer.
When using the Remote Notice function, perform the required settings for connecting to the Fujitsu
remote server.
Settings for Connecting Server
Perform the settings required to connect to the server. Install the drivers and perform the Fibre Channel
switch setting.
Copyright 2009 FUJITSU LIMITED
"4.3 ETERNUS2000 Setup"
"4.3.1 Basic Setup"
"4.3.2 Advanced Copy Setup"
"4.3.3 AC Automatic Linkage Mode Setup"
"4.4 Installing and Setting up ETERNUSmgr"
"4.5 Maintenance Setup"
"4.6 Setting up the Server Connection"
"Chapter 6 Operation and Troubleshooting"
Chapter 2 Hardware
2
43