Fujitsu Eternus2000 Manual page 106

4.2 Cable Connection
6
When 4U AC outlet box is installed
The procedure to connect the power cord to 4U AC outlet box is as follows:
1
82
Turn the main line switch of the AC outlet box to the "On" position (marked "I").
Mai n L ine S w itc h
When turning the main line switch to "On" (marked "I") right after
IMPORTANT
turning the main line switch to "Off" (marked "O"), turn it back to
"On" (marked "I") after the POWER STATUS LED of the power
unit has turned off completely.
(It takes about ten seconds for the POWER STATUS LED to be
turned off completely.)
Remove the power cord clamps from the AC outlet box.
Power cord clamp
Screw
Screw
Copyright 2009 FUJITSU LIMITED
Unplug
• If the ETERNUS2000 is not going to be used for a long
period of time, it is advisable to unplug all power cords to
avoid any chance of fire to the ETERNUS2000 and its
peripherals.
ETERNUS2000 disk storage system User Guide P3AM-2512-03EN