Installing Controller Enclosure - Fujitsu Eternus2000 Manual

3.2.1

Installing Controller Enclosure

This section describes how to mount the controller enclosure in a rack.
WARNING
CAUTION
1
Refer to "ETERNUS2000 models 100 and 200 disk storage system Package
Contents" to confirm there are no missing parts for the rack mount kit.
2
Adjust the bracket sizes to fit the rack.
Reposition the M4 screws to adjust the length of the brackets to match the distance between the
front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the bracket must be
attached to the rack before they can be completely tightened.
3
Attach the bracket to the rack.
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Warning
For these operations, be sure to turn off the device connected to the
ETERNUS2000 (such as servers) when it is turned on, and remove the
power cord from the outlet or it may lead to electronic shock.
Do Not
Do not move disk drives where RAID group, volume and hot spares are
set to another group.
Distance Between Front and Rear Rack Pillars
M4 screws
• When the holes in the rack pillars are square, use the screw
Point
holders to attach.
• Attach brackets to the outside as far apart as possible.
Copyright 2009 FUJITSU LIMITED
Bracket L
Chapter 3 Installation
3
49