Fujitsu Eternus2000 Manual page 92

4.2 Cable Connection
LAN cable connection procedure
The following explains how to connect the LAN cable.
1
2
68
When connecting LAN cables, check the connector orientation and then
Point
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the con-
nector.
Connect the LAN cable to the ETERNUS2000.
Connect the LAN cable connectors to the iSCSI ports of the controller 0 (CM#0) and controller 1
(CM#1) for the ETERNUS2000.
If any one of the iSCSI ports is to be used, it should be "0" on each CM.
CAUTION
• When connecting the LAN cables, position them so that they
Connect the LAN cables to the server or the switching hub.
Connect the other end of the LAN cable to the LAN card / iSCSI HBA of the server or the switch-
ing hub. For details about connecting to the switching hub, refer to the user guide for the switching
hub to be connected.
Copyright 2009 FUJITSU LIMITED
Do
will not obstruct replacement of the power supply unit or con-
trollers by the maintenance engineer.
ETERNUS2000 disk storage system User Guide P3AM-2512-03EN