Minisas Cable Connection (For Drive Enclosures) - Fujitsu Eternus2000 Manual

4.2.5

MiniSAS Cable Connection (For Drive Enclosures)

When a Drive Enclosure is installed, connect the Drive Enclosure to the Controller Enclosure with a mini-
SAS cable. When multiple Drive Enclosures are installed (only for ETERNUS2000 model 200), connect
the Drive Enclosures with miniSAS cable.
Two miniSAS cables (75cm) are supplied with Drive Enclosure.
CAUTION
P3AM-2512-03EN ETERNUS2000 disk storage system User Guide
Do
• Before starting, make sure to attach a wrist strap or touch the metal
frame of the device to eliminate static electricity. Failure to discharge
static electricity may cause device failure.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause device damage.
Do Not
• Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
90
Do not bend square
Copyright 2009 FUJITSU LIMITED
Do not bind up
Chapter 4 Setup
4
71