Microphone Connection - Icom IC-E2820 Instruction Manual

QUICK REFERENCE GUIDE
D Controller/Separation cable connection
Two connection cables, controller cable
body installation and separation cable
stallation, are supplied with the IC-E2820.
Connect the controller and the main unit using with the sup-
plied connection cable as follows.
Controller
4-pin connector
IMPORTANT!— number of pin
The connectors on the ends of the connection cable have dif-
ferent numbers of pins - one end has 6 pins and the other end
4 pins. You should connect the 6-pin connector to the main
unit, and the 4-pin connector to the controller.
III
for single
(10 cm)
for remote in-
(3.4 m)
Main unit
6-pin connector
D Microphone connection
A microphone connector is available on the main unit front
panel. Connect the supplied microphone connector as illus-
trated below.
Controller
Main unit
Attach the supplied microphone connector plate after the mi-
crophone connection, otherwise the controller will separate
from the mail unit when the microphone cable is pulled during
single body installation.
Microphone