Icom IC-E2820 Instruction Manual page 87

[EXAMPLE]: Programming the bank name "AIR" into the scan edge channel 3A.
Memory mode
M/CALL
Push
MW
Rotate
channel 3A.
Push and hold
to enter select memory write condition.
Select memory write mode
*Select "M NAME" or "S NAME" when programing the memory name or the
scan name, respectively.
D D To indicate the channel name
The channel name indication can be set independently for
each memory channel.
q Select the desired memory channel in the main band.
➥ Push the same band's [M/CALL•MW] several times to
select memory mode, then rotate the same band's [DIAL]
to select the desired memory channel.
• "X" and memory channel number appear.
w Push [F•
] to display the function guide.
(Main band's) to select memory mode.
(Main band's) to select scan edge
M/CALL
(Main band's) for 1 sec.
MW
MEMORY MODE OPERATION
Bank name edit mode
S.MW
M/CALL
Push and hold (Left band's) for 1 sec. to program.
MW
ePush [M.N](LOW•PRIO) several times to select "MEMORY
NAME," "FREQUENCY" or OFF.
• When "MEMORY NAME" is selected, the programmed memory
name is indicated above frequency indication; when "FRE-
QUENCY" is selected, the programmed memory name is indi-
cated at the frequency indication and the programmed frequency
is indicated above the memory name.
r Push [F•
] twice to exit the function guide indication.
NOTE: When no memory name is programmed, the stored
frequency is displayed.
SEL
V/MHz
Push (Main band's) several times
SCAN
to select "B NAME".
EDIT
M/CALL
Push (Right band's) to enter bank
MW
name edit mode.
Rotate (Main band's) to
>
M/CALL
select "A", then push .
MW
Enter "I" and "R" with (Main
>
band's) and M/CALL (Left band's), then
MW
BACK
push (Right band's) to select
V/MHz
SCAN
memory write mode.
6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
66