Programming A Memory Channel - Icom IC-E2820 Instruction Manual

6
MEMORY MODE OPERATION

■ Programming a memory channel

VFO settings, including MENU group contents such as sub-
audible tone frequency and offset can be programmed into a
memory channel.
qSet the desired frequency in the desired band
➥ Push the desired band's [V/MHz•SCAN] to select VFO
mode.
➥ Set the frequency using the same band's [DIAL].
➥ Set other data
if required.
w Push and hold the same band's [M/CALL•MW] for 1 sec.
• 2 beeps sound
• "X" indicator and the memory channel number blink.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the controller.
V/MHz
Push
SCAN
Rotate
61
(e.g. tone frequency, duplex information, etc.)
Rotate for setting frequency, etc.
Push and hold
"
"
Beep
"
Beep
"
Beep
"
eRotate the [DIAL] to select the memory channel to be pro-
grammed.
• Memory channels not yet programmed are blank.
rPush and hold [S.MW](M/CALL•MW)
.
(left or right)
to program.
• 3 beeps sound
• Memory channel number automatically increases when contin-
uing to push [M/CALL•MW] after programming.
✔FOR YOUR ONVENIENCE
Memory programming can be performed in various ways e.g.
memory channel to the same (or different) memory channel,
memory channel to the call channel, etc.
M/CALL
Push and hold
MW
"
"
Beep
"
"
Beep
"
S.MW
M/CALL
for 1 sec. and continue to push
MW
(Left band's)
for 1 sec.
➠
"
Beep
for 1 sec.