Main Unit - Icom IC-E2820 Instruction Manual

1
PANEL DESCRIPTION

■ Main unit

q
y
q CONTROLLER CONNECTOR [CONTROLLER]
Connects the controller unit with the supplied controller or
separation cable.
w DATA JACK [DATA]
Connect to a PC via the optional data communication cable
OPC-1529R for data cloning with the optional cloning soft-
ware, CS-2820, or low-speed data communication in DV*
mode operation.
*Available only when the optional UT-123 is installed.
9
w e r t
u i o !0
!1
(p. 57)
e GPS ANTENNA CONNECTOR [GPS ANT]
When the optional digital unit, UT-123, is installed, con-
nects the GPS antenna supplied with the optional UT-123.
rPACKET JACK [PACKET]
Connects a TNC
communications. The transceiver can support 1200/9600
bps packet communication
t MICROPHONE CONNECTOR [MIC]
Connects the supplied or an optional microphone.
i
(p. III)
y ANTENNA CONNECTOR [ANT1 TX/RX]
Connects a 50 Ω antenna with a PL-259 connector and a
50 Ω coaxial cable for transmission and reception.
u COOLING FAN
Rotates while transmitting.
Also rotates while receiving depending on the setting in set
mode.
(p. 99)
(pgs. 118, 119)
(Terminal Node Controller)
.
(AFSK/GMSK)
(p. III)
q +8 V DC output (Max. 10 mA)
w Channel up/down
e 8 V control IN
r PTT
t GND (microphone ground)
q
y MIC (microphone input)
u GND
i Data IN
(p. IV)
, etc. for data
(p. IX)