I Microphone Connection; I Separate Installation - Icom IC-207H Instruction Manual

2
INSTALLATION

I Microphone connection

The microphone connector is located behind the front panel.
Connect the supplied microphone as follows:
➀
Slide the supplied microphone cable connector (and at-
tached microphone) into the microphone jack on the main
body of the transceiver until it clicks into place.
➁
To remove the microphone, push the release lever on the
bottom of the microphone cable connector.
Microphone pin assignments
➀ 8 V OUT
➁ Freq. up/down
➀ ➇
➂ 8 V control IN
➃ PTT
➄ Mic AF (–)
➅ Mic AF (+)
➆ Ground
➇ Data IN
11

I Separate installation

Using an optional OPC-600/601
panel can be separated from the main body, doubling as a re-
mote controller.
➀
Detach the front panel as
at right.
➁
Connect
cable between the front
panel and main body
using the supplied screws
as illustrated below.
Rear of front panel
Connect microphone
here
SEPARATION CABLE
a separation
Main body
OPC-600 or OPC-601
, the front