Scan Resume Condition - Icom IC-E2820 Instruction Manual

8
SCAN OPERATION

■ Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch.
(p. 80)
The display shows that the scan will resume
15 sec. after it stops.
qPush [MAIN•BAND] to select the desired band
as the main band.
w Push [F•
] to display the function guide.
ePush [MENU](V/MHz•SCAN]
screen.
rRotate the [DIAL] to select
[MAIN•BAND].
tRotate the main band's [DIAL] to select
then push [MAIN•BAND].
y Rotate [DIAL] to select the desired timer:
• "T-5" : Scan pauses 5 sec. while receiving a signal.
• "T-10" : Scan pauses 10 sec. while receiving a signal.
• "T-15" : Scan pauses 15 sec. while receiving a signal.
• "P-2" : Scan pauses until the signal disappears and then re-
sumes 2 sec. later.
u Push [MAIN•BAND] to set.
iPush [BACK](V/MHz•SCAN)
to frequency indication.
77
(left or right)
to enter MENU
(Right band's)
SCAN, then push
" "
SCAN TIMER,
" "
twice to return
(Right band's)
z Push [BAND] to select the desired band
SET
as the main band.
right)
B
x Push [
B(D-OFF)] to enter MENU screen.
SET
c Push [Y] or [Z] to select "SCAN" then push
[ B(D-OFF)] to enter scan set mode.
SET
v Push [Y] or [Z] to select "SCAN TIMER" then
push [ B(D-OFF)].
SET
b Push [Y] or [Z] to select the scan resume condi-
tion, then push [
SET
• See item y at left for scan resume condition details.
n Push [
A(MW)] to exit set mode.
CLR
(left or
B(D-OFF)].