Dtmf Memory Encoder; I Programming A Dtmf Code; I Clearing The Dtmf Memory Contents - Icom IC-207H Instruction Manual

I Programming a DTMF code

DTMF codes are used for autopatching, accessing repeaters,
controlling other equipment, etc. The transceiver has 14
DTMF memory channels (d0– d9, dA–dd) for storage of often-
used DTMF codes of up to 16 digits.
NOTE: DTMF memory channels are commonly used for
both bands. Therefore, programming each band is not
necessary.
➀
Push for one sec. and "d" appears in place of the
DTMF
100 MHz digit as shown below.
"d" appears in place of
H I
the 100 MHz digit.
➁
Push [SET] to enter the programming condition.
➂
Rotate the tuning dial to select the desired channel.
➃
Push [SET] or [MONI] to select the cursor.
➄
Rotate the dial to select a digit.
• "E" stands for "M" and "F" stands for "#."
➅
Repeat steps ➃ and ➄ until the last digit is entered.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
• Select "–" to clear the remaining digits when programming over a
previously used memory channel.
➆
Push [V/MHz] exit the programming condition.

DTMF MEMORY ENCODER

I Clearing the DTMF memory
contents
➀
Push
ON.
➁
Push [SET] to enter the programming condition.
➂
Rotate the tuning dial to select the desired channel.
➃
Push [SET] to activate the 1st digit.
➄
Rotate the tuning dial to select "–" and clear the memory
channel contents.
➅
Push the tuning dial to exit the programming condition.
9
5
1
for 1 sec. to turn the DTMF memory encoder
DTMF
11
46