Show Interface - Qlogic SANbox 5000 Series Interface Manual

A

Show Interface

Displays the status of the active network interfaces.
Authority
None
Syntax
show interface
Examples
The following is an example of the Show Interface command:
SANbox #> show interface
eth0
59183-01 A
Link encap:Ethernet HWaddr 00:C0:DD:00:BD:ED
inet addr:10.20.68.107
UP BROADCAST RUNNING MULTICAST
RX packets:4712 errors:0 dropped:0 overruns:0 frame:0
TX packets:3000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:415313 (405.5 Kb)
Interrupt:11 Base address:0xfcc0
RX bytes:20116 (19.6 Kb)
Bcast:10.20.68.255 Mask:255.255.255.0
MTU:1500 Metric:1
TX bytes:716751 (699.9 Kb)
TX bytes:20116 (19.6 Kb)
13 – Command Reference
Show Interface
13-113