Reports Menu - Extreme Networks Summit WMScanner User Manual

WMScanner GUI and Menus
Visualize Survey
Data
Visualization
Options
Import
Measurement Data
Export
Measurement Data
Delete
Measurement Data
Access Point
Associations
Display
Measurement Data

Reports Menu

Summit WMScanner provides an extensive reporting capability that network designers can use to
document all aspects of their WLAN design including project information, design parameters,
measurement data results, and measurement heatmaps. This information is output in MS Word format
for easy viewing, editing, and archiving. To launch the reporting feature, select Reports > Run Reports:
NOTE
Before generating reports for Microsoft Word, ensure the rfreports.dot is selected as the primary template. Use the
following steps to set rfreports.dot as the template:
42
This command allows you to view data based on real WLAN measurements.
Invoking this command opens the Visualization panel, allowing you to select
from the following types of heat maps:
Channel Grid
Coverage Grid
SNR Grid
SSID Grid
Data Rate Grid
Noise Grid
Hybrid Network Overlap Grid
Channel Width Performance Grid
Channel Width Configuration Grid
Data Rate Performance Grid
See "Visualizing Survey Data" on page 100
This command opens the Visualization Options dialog, which allows you to set
the Visualization Boundary, Distance Visualization Limit, and Grid Bin Size.
See "Configuring Measurement Visualizations" on page 104
This command allows you to import an ASCII (plaintext) measurement logfile
created by Summit WMScanner. See
page 119 for details.
This command allows you to export measurement data embedded within the
drawing to an ASCII (plaintext) logfile. See
on page 120 for details.
This command allows you to remove measurement data from the current
drawing. Your measurement data logfile, however, will still remain on your hard
drive unless you select the option to "Erase Logfile" on the Measurement Run
Delete dialog box that prompts you for the measurement run you would like to
remove. See "Deleting Measurement Data" on page 121
Allows you to identify which measurement runs correspond to which access
points in the drawing file.
This command is used to set, show, hide and change the marker settings.
for details.
for details.
"Importing Measurement Logfiles" on
"Exporting Measurement Logfiles"
for details.
Summit WMScanner Users Guide