Extreme Networks Summit WMScanner User Manual page 176

Model Building
You are prompted to select two locations by left clicking your mouse at two different points in the
drawing. After selecting two points, you will then be prompted to enter the physical real world
distance between those two points.
The check box option to Lock cursor to line endpoints during scale enables you to accurately scale the
drawing based on the distance from the end point of one wall to the end point of another wall.
Using this option will cause your mouse cursor to exactly lock onto the end of wall, even if you do
not click precisely on an end point.
information on scaling an already assembled final drawing without using the Building Floor
Manager.
5 Set the Floor Alignment Point.
This step requires you set an alignment point for the floor. The alignment point you choose will
become the origin for the x-y plane represented by a top-down view of the drawing. The Building
Floor Manager uses the origin of the x-y plane to align building floors vertically with the Assemble
Floors command. Therefore, it is important you choose a floor alignment point that is common
among all floors that you wish to align. You can also choose a common point on an elevator shaft or
stairwell. For example, choosing the bottom left corner of every floor will often work well for
rectangular shaped floors.
To set the floor alignment point, press the Set Alignment Point button and click the point in the
drawing you wish to become the origin.
174
"Editing Partitions and RF Obstructions" on page 192 provides
Summit WMScanner Users Guide