Extreme Networks Summit WMScanner User Manual page 170

Model Building
You will be asked to perform two tasks when you press the Assemble Floors button: (1) Set the legend
position and (2) Verify the drawing. These two steps are described in detail in the sections that follow.
Drawing Legend.
When you assemble the building floors, the Drawing Legend dialog box appears.
The information you enter in the Drawing Legend dialog box are for your reference and may be
●
filled out with any text that you wish. The check boxes in the lower left corner of the Drawing
Legend dialog box allows you to set what information the legend displays in the drawing
window. Once you have configured the legend, use the Set Position button to configure where the
legend will be displayed in the drawing window. When you press the Set Position button, you
will then be prompted to click in the drawing to set the new legend position. Choose the point in
the drawing where you want the lower left corner of the legend to appear.
Once you have finished configuring and placing the legend, press the OK button to dismiss the
●
Drawing Legend dialog box and continue to the Verify Drawing step. You may edit the drawing
legend at a later time by accessing the menu command Utilities > Legend.
Verifying Drawing Assembly.
Once you chosen to assemble building floors and then configured the drawing legend, you will be asked
to verify that the drawing appears as you intended it to. This is your opportunity to make sure that you
properly set the alignment points for a multi-floor building by making sure the floors stack up properly.
The Verify Drawing dialog box allows you to view the assembled drawing from multiple perspectives
and to make sure floors are scaled relative to each other.
168
Summit WMScanner Users Guide