Extreme Networks Summit WMScanner User Manual page 134

Measurement Surveys
To place hardware in the drawing, double left click the hardware description in the Place Access Point
dialog box and then left click at the location in the drawing where you would like the access point
placed. If the access point you are placing has antenna's that are attached via cables, then click again in
the drawing to specify the location of the antenna relative to the access point. You may continue to
place multiple access points by clicking in the drawing again.
To place access points on a different floor, use the floor drop-down menu located on the lower-right
side of the Place Access Point dialog box to change the floor currently displayed in the drawing.
Summit WMScanner Users Guide
132