Extreme Networks Summit WMScanner User Manual page 179

Complete the following steps to properly format an unformatted drawing file:
1 Select File Import Location.
Choosing to import an unformatted floor will display an additional option where you must select
the location of the unformatted file you wish to import. Use the Browse button to locate your
unformatted file on disk, then press Next to proceed to step two. It is a good idea to store your
unformatted files in the unformatted folder of your project workspace. This is the default folder
opened when clicking the Browse button. Files will also be copied there when opened from another
location.
2 Set Slab-to-Slab Height
This follows the same process as
3 Format the Floor
This step is used to process the unformatted floor.
Press the Format Floor button to temporarily leave the Floor Formatting Wizard so that you may
process the unformatted file. Pressing the Format Floor button will give you different formatting
options based on the type of unformatted input file you chose in step one. If you chose to import a
Summit WMScanner recognized CAD file format, you will be taken to the Format CAD Drawing Process
dialog box. If you chose to import a raster file in step one (such as a bitmap or jpeg), you will be
taken to the Draw Partition dialog box.
Summit WMScanner Users Guide
"Set the Slab-to-Slab Height." on page 171.
177