Utilities - Geo-Reference Building - Extreme Networks Summit WMScanner User Manual

After you have created the new project workspace, select Done to exit the Project Workspace dialog.
Now, the active project workspace is the one you just created.

Utilities - Geo-Reference Building

Summit WMScanner enables you to geo-reference your drawing. Summit WMScanner allows you to
record the latitude and longitude coordinates for a given set of points in your drawing, effectively geo-
referencing these points. To geo-reference a drawing, you will first need to record a set of x, y, and z
coordinates, and then associate the known geographic coordinates of these coordinates from a given
coordinate system, WGS84 in this case.
Select Utilities > Geo-Reference Building menu to open the Geo-Reference Building dialog box.
This dialog box allows you to pick the x, y, z coordinates from the drawing, remove them, and edit
them. Once you are done with picking the x, y, z points, you can export them to WMS, along with the
drawing.
Pick Points – this option allows you to pick two points from the drawing: ideally, upper left and
●
lower right. Click the Pick Points button and then click the left top or right bottom corner in the
drawing to record the x-y coordinates of the drawing. Once you record the x-y coordinates of the
drawing, enter the WGS84 latitude and the longitude of the point you picked from the drawing.
Click again on the drawing to get the other set of coordinates. Enter the WGS84 latitude and
longitude for the new set of points.
Summit WMScanner Users Guide
55