Command Device Selection Panel - HP XP P9500 Reference Manual

NOTE:
If you are using the HP XP1024/XP128 Disk Array, take the target command device offline
before executing the YKDELCMD command.
For the following models, you can execute the YKDELCMD command regardless of whether
the target command device is online or offline:
◦
HP XP12000/XP10000 Disk Array
◦
HP XP24000/XP20000 Disk Array
◦
HP P9500 Disk Array
When the YKDELCMD command is executed, the copy pair created in the storage system to
which the target command device belongs becomes inoperable. Dissolve the copy pair before
executing the YKDELCMD command.
When the command device on the primary site is shared between the route of Primary to Local
and the route of Primary to Remote in the 3DC Multi-Target configuration route list, the command
device on the primary site must be deleted at the end.

Command Device Selection Panel

If f is selected in the AC column in the Route Status panel, the Command Device Selection List
panel for displaying the command devices registered in the storage system is displayed.
Figure 88 (page 103)
Figure 88 Command Device Selection List Panel
Table 61 (page 103)
Table 61 Contents of the Command Device Selection List Panel
Item
Device Address Domain ID
Description
Model
shows the Command Device Selection List panel.
describes the items in the Command Device Selection List panel.
Description
DAD ID
Description of the storage system specified in the Host-Discovered Array
structure
Storage system model
9900V: HP XP1024/XP128
USP: HP XP12000/XP10000
Manage Route Panel (Route Management) 103