Executing Ykbldcmd; Executing Ykdelcmd - HP XP P9500 Reference Manual

Executing YKBLDCMD

When b is specified in the AC column in the Route Status panel, the YKBLDCMD command is
executed to register a command device to storage system. The Confirm Command Device Build
panel (see "Confirm Command Device Build Panel" (page
When registering a command device, perform the settings in order, starting from the primary site
and progressing towards the more distant site (in the order in which they are defined in the route
list).
If b is specified for multiple ACs in the Route Status panel, they will be processed sequentially from
the top of the list.
Even when b is specified for multiple ACs in the Route Status panel and is specified not to display
the Confirm Command Device Build panel, the Confirm Command Device Build panel will be
displayed after an error and before processing the next volume.
NOTE:
After turning power on for the storage system, execute the YKBLDCMD command only once.
If you execute this command more than once, when the command device has already been
registered in storage system, the command device will not be registered. Before executing this
command, make sure that the target command device does not control the storage system.
If a command device is registered, do not delete the path to the storage system (inter-CU
logical path or inter-DKC logical path).
Take the target command device offline before executing the YKBLDCMD command.

Executing YKDELCMD

When d is specified in the AC column in the Route Status panel, the YKDELCMD command is
executed to delete a command device which is registered to the storage system. The Confirm
Command Device Delete panel (see
displayed.
To delete a command device, perform deletion in the reverse order of the route list definition,
starting from the most distant site where a command device has been already registered, progressing
towards the primary site. For details about how to delete a command device, see the HP P9000
for Business Continuity Manager Software Users Guide.
If you specify d for multiple fields in AC in the Route Status panel, processing will be performed
from bottom to top.
Even when d is specified in multiple ACs in the Route Status panel and is specified not to display
the Confirm Command Device Delete panel, the Confirm Command Device Delete panel will be
displayed after an error and before processing the next volume.
102 ISPF Panels
"Displayed from Route Status Panel" (page
171)) will be displayed.
173)) will be