HP XP P9500 Reference Manual page 207

SWAPPING
Applies to Continuous Access Synchronous for Mainframe, Continuous Access Synchronous for
Mainframe with the HyperSwap attribute, Continuous Access Asynchronous for Mainframe, and
Continuous Access Journal for Mainframe.
The command waits until all copy pairs in the group reach the SWAPPING status. However, if the
status of any copy pair changes to the SIMPLEX, HOLD, HOLDER, HOLDTRNS, NODELTA,
CONSLOST, or INVALID status, the YKEWAIT command terminates abnormally with return code
8.
TIMEOUT(timeout-value) ~ <numeric characters> ((0 to 9999))
Specify a timeout value in minutes. If the specified duration has elapsed before the status specified
by the GOTO parameter is attained, the YKEWAIT command checks the status of the copy group
at that moment. If the status is the same as the one specified in the GOTO parameter, the command
terminates normally (return code = 0). If not, it terminates abnormally with the return code 4.
If 0 is specified in TIMEOUT parameter, it looks at the status of the copy group immediately, and
then returns as described previously.
For CG containers specified by EXCTG ID, if this time value elapses before all journal groups are
registered in EXCTG, the YKZ298W message is output and the YKEWAIT command terminates
abnormally with return code 4. If the YKZ298W message is output, the REXX variable is disabled
(the same state as before the YKEWAIT command was executed).
NOINVALIDCHECK
Processing continues even when the status changes to anything other than the status specified by
the GOTO parameter (invalid statuses). If this parameter is specified, and the status does not change
to that specified in the GOTO parameter, command processing will continue until the timeout time
specified in the TIMEOUT parameter is reached.
The invalid statuses in
parameter. The table shows an invalid status for each value specifiable in the GOTO parameter.
Table 106 Invalid Status for Each Value Specifiable in the GOTO Parameter
Value of GOTO Parameter
DUPLEX
SUSPEND
SIMPLEX
SUSPVS
HOLD
SWAPPING
When the command waits for copy pairs in the CG container specified by EXCTG ID to reach
DUPLEX status, it first waits for all journal groups in the CG container specified by EXCTG ID to
be registered in EXCTG. If an error is detected during EXCTG registration, the YKZ297E message
is output and the command terminates abnormally with return code 44.
Table 106 (page 207)
Invalid Statuses
SIMPLEX, SUSPCU, SUSPER, TRANS, SUSPVS, HOLDER, NODELTA,
CONSLOST, or INVALID
SIMPLEX, SUSPER, SUSPCU, HOLD, HOLDER, HOLDTRNS, NODELTA,
CONSLOST, or INVALID statuses.
SUSPER, SUSPCU, HOLDER, CONSLOST, or INVALID statuses.
SUSPER, SIMPLEX, SUSPCU, HOLD, HOLDER, HOLDTRNS, NODELTA,
CONSLOST, or INVALID statuses.
SIMPLEX, SUSPER, SUSPCU, HOLDER, NODELTA, or INVALID statuses.
SIMPLEX, HOLD, HOLDER, HOLDTRNS, NODELTA, CONSLOST, or
INVALID statuses.
differ depending on the value specified in the GOTO
Command details 207