Configuration Files That Must Be Loaded Before Command Execution - HP XP P9500 Reference Manual

Table 93 List of Supported Functions (continued)
Command
YKEXPORT
YKFCSTAT
YKFREEZE
YKH2B
YKIMPORT
YKINSCHK
2
YKLOAD
YKMAKE
YKQHPATH
YKQRYDEV
YKQRYPTH
YKQUERY
YKRECVER
YKRESYNC
YKRUN
YKSCAN
YKSLEEP
YKSTATS
2
YKSTORE
YKSUSPND
3
YKWATCH
4
YKWTOMSG
1
The YKWTOMSG and YKDROP commands are REXX functions.
2
The YKLOAD and YKSTORE commands are REXX subroutines.
3
The YKWATCH command is a REXX script.
4
The YKWTOMSG command is a REXX function.

Configuration Files That Must Be Loaded Before Command Execution

Table 94 (page 184)
before each command is executed.
Function
Outputs the contents of a copy group definition file to a CSV file.
Acquires the FlashCopy information for the specified volume.
Freezes the specified copy group, changes it to the SCP status, and then suspends
update I/O for the P-VOL.
Scans the active PPRC copy pairs and automatically generates a copy group
definition file for a CA copy group with the HyperSwap attribute.
Reads a CSV file and creates a copy group definition file.
Checks if all installation and setup tasks have been completed.
Reads values from the configuration file defined in the ISPF panel and converts
them to REXX variables that are valid on the target host.
Makes a copy pair by full copy and changes the volume status to the DUPLEX status.
Displays the I/O path status between the host and the storage system.
Displays information about the specified volume.
Acquires the status of the physical paths allocated to all or some of the inter-DKC
or inter-CU logical paths included in the path set information loaded by the YKLOAD
command.
Displays copy pair information.
Dissolves a copy pair from an S-VOL and changes the volume status to the SIMPLEX
status.
Resynchronizes a copy pair by differential copy and changes the volume status to
the DUPLEX status.
Cancels the SCP status for the specified copy group and makes the update I/O for
P-VOL enabled.
Scans the entire range of device numbers and generates the REXX variables for all
volumes found.
Temporarily stops script execution for a specified time.
Acquires the operating information for the specified copy group.
Converts the REXX variables that are valid on the target host and writes the converted
values to the configuration file defined in the ISPF panel.
Suspends a copy pair and changes the volume status to the SUSPOP status.
Monitors the copy pair status transition and waits for a previously specified status.
Outputs a message that is specified on the OS console.
and Table 95 (page 185)
Configuration Files That Must Be Loaded Before Command Execution 183
show the configuration files that must be loaded