Executing Ykdelcmd; Route Status Panel (Route Management) - HP XP P9500 Reference Manual

1
If the specified action has been aborted, the execution result (RC) is not displayed correctly.
When you change or delete the route list, command devices defined in the list can remain registered
in the storage system. You can use this panel to directly operate such devices by entering the
appropriate DAD ID and storage system serial number to specify the storage system, as well as
the device number of the command device. In this case, the command devices that you can operate
are those for which a device number (Devn) is defined in the disk configuration definition file.

Executing YKDELCMD

If you specify d on the Extra Command Device Direct Operation panel, the YKDELCMD command
is executed to delete the command device information registered in the storage system, and the
Confirm Command Device Delete panel (see
Operation Panel" (page
NOTE:
When using the HP XP1024/XP128 Disk Array, take the target command device offline before
executing the YKDELCMD command.
For the following models, you can execute the YKDELCMD command regardless of whether
the target command device is online or offline:
◦
HP XP12000/XP10000 Disk Array
◦
HP XP24000/XP20000 Disk Array
◦
HP P9500 Disk Array
For the HP XP1024/XP128 Disk Array, you can only delete command devices registered in
storage systems that are directly connected to the host. You cannot delete remote storage
system command devices.
Take care not to delete command devices defined in the route list.

Route Status Panel (Route Management)

The Route Status panel is displayed when s is specified for the AC column in the Manage Route
panel. The following table shows the Route Status panel when the F1 1=CCAInfo key is pressed on
the Route Status panel.
Route number
List number
DAD ID
Label
APID
Serial number
Devn
SSID
CU number
CCA
Volser
96 ISPF Panels
173)) is displayed.
Item
Displayed
Not displayed
Displayed
Not displayed
"Displayed from Extra Command Device Direct
F10=DADInfo key F1 1=CCAInfo key
Displayed
Not displayed
Displayed