Add Route List Id Panel; Route List Information Panel - HP XP P9500 Reference Manual

The route list definition is required when using the Remote DKC Control Function and the Cnt Ac-S
consistency preservation function. It defines routes between devices and command devices so that
these devices are available.
The route list ID list is displayed in the Route Config panel.
To create a route list ID, place the cursor on the field and press F5=Add.

Add Route List ID Panel

In the Route Config panel, pressing the F5=Add key displays the Add Route List ID panel for setting
the route list ID.
The Add Route List ID panel to create a new route list is shown in
Figure 32 Add Route List ID Panel
In the Add Route List ID panel, specify a route list ID using no more than 8 alphanumeric characters
or less. Do not use hyphens.
When editing the route list definition (APID update, route deletion, or command device definition),
the Confirm Route List Edit panel prompts you to confirm the update. For more information on the
Confirm Route List Edit panel, see
If you change the route list definition, and then press F3=Exit to update the route list, the Confirm
Configuration File Update panel is displayed. For information on the Confirm Configuration File
Update panel, see

Route List Information Panel

If s is specified for AC in the Route Config panel, the Route List Information panel is displayed.
The list of storage systems included in the route defined in the selected route list is displayed in the
Route List Information panel.
The Route List Information panel is shown in
44 ISPF Panels
"Confirm Route List Edit Panel" (page
"Confirm Configuration File Update Panel" (page
Figure 32 (page
Figure 33 (page 45).
44).
178).
175).