Processing For Changing To The Startup Status - HP XP P9500 Reference Manual

STOP
Changes the monitoring status of all the copy groups specified in the CGID parameter to INACTIVE.
ADJUST
Changes the copy pair status to the specified startup status.
Processing depends on the status of copy pairs in the copy group. For details on the processing
for changing the status to the startup status, see
(page 363).
NOCANCEL
Does not execute the YKSUSPND command with the CANCEL parameter specified. You can specify
this value only if you specified DUPLEX as the startup status.

Processing for Changing to the Startup Status

This section describes the processing of changing the copy group to the startup status when ADJUST
is specified for the CGSTARTUPSTATUS parameter. The copy group is sequentially searched for
a copy pair in the status indicated in the copy pair status column in
Startup Status" (page
the processing column is performed for the copy group.
Table 158 Processing for the Specified Startup Status
Specified startup status
SIMPLEX
DUPLEX
363). If such a copy pair with the indicated status is found, the processing in
Copy pair status
All SIMPLEX
SWAPPING
TRANS
INVALID
SUSPVS
REVRSY
CONSLOST
PENDING
DUPLEX
SUSPOP
SUSPCU
SUSPER
HOLD
HOLDER
HOLDTRNS
NODELTA
All DUPLEX
PENDING
SIMPLEX
SWAPPING
SUSPER
"Processing for Changing to the Startup Status"
"Processing for the Specified
Processing
Does nothing.
Places the monitoring status of all copy
groups specified in the CGID parameter
to INACTIVE.
Executes the following commands:
YKDELETE
YKEWAIT GOTO(SIMPLEX)
Does nothing.
Places the monitoring status of all copy
groups specified in the CGID parameter
to INACTIVE.
YKMONCG File 363