HP XP P9500 Reference Manual page 70

Figure 60 Copy Group Detail Definition Panel
"Items in the Copy Group Detail Definition panel" (page 70)
Detail Definition panel. Note that changes for each item will be applied to the storage system
settings when the copy pair is reloaded (by executing the YKLOAD command) and then created.
For Continuous Access Synchronous for Mainframe copy pairs with the HyperSwap attribute,
because Business Continuity Manager cannot perform copy pair operations, if you change the
definitions of the items that require the YKMAKE command to make changes, the changes will not
be applied to the storage system settings.
Table 46 Items in the Copy Group Detail Definition panel
Item
Copy Group Type
Copy Group ID
Description
Primary Device Address
Domain
Secondary Device Address
Domain
Enable EXCTG Attributes
EXCTG ID (Forward)
EXCTG ID (Reverse)
Use Container
AC
70 ISPF Panels
Description
Copy type of the copy group
Copy group ID
A description of the copy group (can be edited)
Primary DAD ID
Secondary DAD ID
Specify / to define an EXCTG attribute.
This is only effective when the copy type is CAJ; if the copy
type is other than CAJ, an error message is displayed.
Specify an EXCTG ID (0 to 3) for copying in the forward
direction.
Specify an EXCTG ID (0 to 3) for copying in the reverse
direction.
Select to define a container.
This check box cannot be cleared if there are multiple copy
groups.
Specify an action.
e: Edits a copy pair in the copy group. This setting
displays the Copy Group Pair Detail panel (this setting
describes the items in the Copy Group
When effective
When the YKMAKE
command is executed
N/A
N/A
N/A
N/A
2
When the YKMAKE
command is executed
When the YKMAKE
command is executed.
Unless all volumes are
SIMPLEX, execution
might not be executed
properly.
When the YKMAKE
command is executed.
When the YKMAKE
command is executed.
N/A
1
1
.
1
1
1