HP XP P9500 Reference Manual page 128

Table 72 Contents of the Copy Group Pair Status Panel (continued)
Item
C/T ID
sub C/T ID
State
Match Rate%
CT Delta
DDD HH:MM:SS
VOLSER
Pri Devn
EX
Dir
Sec Devn
EX
AC Result
128 ISPF Panels
Description
d: Executes the YKDELETE command to dissolve copy pairs. See
YKDELETE" (page
c: Executes the YKRECVER command to dissolve copy pairs from the
secondary site. See
p: Executes the YKQRYDEV with the PATH parameter specified in order to
obtain the logical path information that is used by copy pairs. See
Set Status of Copy Group Pair Panel (YKQRYDEV with PATH Parameter
Specified)" (page
Consistency group ID at definition
Subconsistency group ID at definition
Copy pair status
Copy pair matching rate
Displays the difference between the consistency time of the suspended S-VOLs
and the current time when a copy pair is suspended in CAA or CAJ.
When BC or CA, or information cannot be acquired from the secondary site,
(for example, the command device is not defined), it is not displayed. Only
if the C/T group timer type is SYSTEM, it is displayed.
For CAJ, the type of consistency time to be used differs depending on the
value specified in C/T TIME MODE of the Copy Group Attribute (CAJ) panel.
For details about the consistency time, see the HP P9000 Continuous Access
Synchronous for Mainframe Systems User Guide: HP XP24000 Disk Array,
HP XP20000 Disk Array or the HP P9000 Continuous Access Synchronous
User Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200
Storage Virtualization System.
Volume serial number
P-VOL device number
Displays the following information that indicates whether the P-VOL is an
external volume.
+: An external volume
-: Not an external volume
(blank): The volume attribute is unknown because it was not requested
Copy direction in the copy pair
This information is changed by the YKQUERY command or YKEWAIT
command.
S-VOL device number
Displays the following information that indicates whether the S-VOL is an
external volume.
+: An external volume
-: Not an external volume
(blank): The volume attribute is unknown because it was not requested.
Action Executed action
RC Execution results for the executed action
If F12=Cancel is pressed in the panel displayed during action specification,
the displayed action results are not updated.
1
163).
"Executing YKRECVER" (page
166).
2, 3
4
"Executing
166).
"Path
3