Volume Query Information (Caj) Panel - HP XP P9500 Reference Manual

4
The timing for when the defined values are reflected is as shown in
5
It is displayed if P-VOL or S-VOL is shared with other copy pairs in the definition (for example, in a 1:n BC copy pair
configuration or when S-VOL for CAA is used as P-VOL for BC).
6
MISMATCH might be displayed. This happens when the device information during definition, as indicated by Primary
Volume and Secondary Volume, differs from the device information reported by the storage system. In this case, the
device information reported by the storage system is displayed in the Pair Volume column. If MISMATCH is displayed,
check the configuration file used, as well as the actual storage system configuration information settings.
NOTE:
If the copy type in the definitions differs from the actual copy type, the Volume Query
Information panel for the actual copy type is displayed.
In the following cases, N/A is displayed for the device information:
◦
When the YKQRYDEV command returns an error
◦
When displaying information about a device of a remote storage system if the route list
has not been loaded or the target storage system is not included in the route list

Volume Query Information (CAJ) Panel

If you specify q in AC on the Copy Group Pair Status panel, the YKQRYDEV command is executed
on the P-VOL and S-VOL, and the Volume Query Information (CAJ) panel is displayed for a CAJ
copy pair.
Figure 1 12 (page 146)
Figure 1 12 Volume Query Information (CAJ) Panel
Table 77 (page 146)
Table 77 Contents of the Volume Query Information (CAJ) Panel
Item
Copy Group ID
Copy Group Type (in Configuration)
Copy Group Type (from Storage System)
146 ISPF Panels
shows the Volume Query Information (CAJ) panel.
describes the items in the Volume Query Information (CAJ) panel.
Table 48 (page 75), in the item When effective.
Description
Copy group ID
Copy type at definition
Copy types held by the
storage system