Command Details; Ykbldcmd Command - HP XP P9500 Reference Manual

Table 95 Configuration Files That Must Be Loaded Before Command Execution (When the Environment
Contains a Non Gen'ed Volume) (continued)
Command name
YKMAKE
YKQHPATH
YKQRYDEV
YKQRYPTH
YKQUERY
YKRECVER
YKRESYNC
YKRUN
YKSCAN
YKSLEEP
YKSTATS
YKSUSPND
YKWATCH
YKWTOMSG
1
You need to load the configuration file when operating a forward-direction path (a path from a P-VOL whose copy type
is CAJ to an S-VOL). You also need to load the configuration file if all of the volumes in the CU are Non Gen'ed volumes
when operating an inter-CU logical path.
2
You need to load the configuration file when the copy type is CAJ.
Legend:
Y: You need to load the configuration file.
D: Whether you need to load the configuration file depends on the situation.
--: You do not need to load the configuration file.

Command details

This section describes command details. For details about the syntax symbols used in the
explanations, see

YKBLDCMD Command

Applies to CMD.
Format
YKBLDCMD
{ SN(storage system-serial-number)|
1
SN(storage-system-serial-number)
1
APID(APID)|
1
DEVN(device-number)
1
MSG(stem-name-1)
1
Function
This command is a TSO/E command called from REXX scripts.
186 CLI Commands
Copy group definition file
Y
--
--
--
Y
Y
Y
Y
--
--
Y
Y
--
--
"Symbols Used in Syntax Explanations" (page 379)
APID(APID)}
1
Configuration file that must be loaded
Route list definition file
2
D
--
Y
1
D
2
D
Y
2
D
--
--
--
2
D
2
D
--
--
CU(CU-number) CCA(CCA-number)
1 1
Path set definition file
--
--
--
Y
--
--
--
--
--
--
--
--
--
--