Copying Diagnostic Data To A Remote Host, Pc Or Unix Workstation; Copying Command Output To A Destination Device - HP PROCURVE 2520 Management And Configuration Manual

File Transfers

Copying Diagnostic Data to a Remote Host, PC or UNIX Workstation

Copying Diagnostic Data to a Remote
Host, PC or UNIX Workstation
You can use the CLI to copy the following types of switch data to a text file in
a destination device:
■
■
■
■
The destination device and copy method options are as follows (CLI key word
is in bold):
■
■

Copying Command Output to a Destination Device

Syntax: copy command-output < "cli-command" > tftp < ip-address > < filepath­
For example, to use Xmodem to copy the output of show config to a serially
connected PC:
A-28
Command Output: Sends the output of a switch CLI command as a file on
the destination device.
Event Log: Copies the switch's Event Log into a file on the destination
device.
Crash Data: software-specific data useful for determining the reason for
a system crash.
Crash Log: Processor-Specific operating data useful for determining the
reason for a system crash.
Remote Host via TFTP.
Serially connected PC or UNIX workstation via Xmodem.
filename >
copy command-output <"cli-command"> xmodem
These commands direct the displayed output of a CLI
command to a remote host or to a serially connected PC or
UNIX workstation.