Table of Contents
Advertisement
Avaya, Inc.
Configuring the System Community
The value that you set must match the write community name
of the SNMP host to enable the SNMP Set operation. If you
enable SNMP but the community name is not set, SNMP goes
into read-only mode.
To configure the system community:
1. On the Main Menu, select Configure SNMP.
The SNMP Configuration Menu displays.
*****************************************
*
SNMP Configuration Menu
*****************************************
E. Enable/Disable SNMP
P. Configure System Contact
N. Configure System Name
L. Configure System Location
C. Configure SNMP Community
T. Configure SNMP Trap Host IP Address
2. Select Configure SNMP Community.
The following instructions display on-screen:
SNMP Community is currently:
Enter new SNMP Community >
3. Type the name of the SNMP community to which your
system belongs or press ENTER to accept the default
value that displays.
You must restart the PARTNER ACS 1600 DSL module
for any changes to take effect. For more information on
restarting the PARTNER ACS 1600 DSL module, see the
"Getting started" chapter.
- 92 - PARTNER ACS 1600 DSL module User Guide
*
Advertisement
Table of Contents
