Table of Contents
Advertisement
8. Configure
Login
Avaya, Inc.
C. Configure SNMP Community
Sets the SNMP community to which your device belongs
(maximum = 39 alphanumeric characters). This name must
match the name of the SNMP host. Type the name, and then
press ENTER.
If SNMP you enable and the Community Name is null, SNMP
goes into read-only mode.
T. Configure SNMP Trap Host IP Address
Sets the IP address of the system setup for trap operations.
Type the IP address, and then press ENTER.
Displays the Password Configuration Menu, which contains
the following commands to set the default User ID and the
default User and Network Administrator passwords:
You must restart the PARTNER ACS 1600 DSL module for
any changes to take effect.
restarting the PARTNER ACS 1600 DSL module, see the
"PARTNER ACS 1600 DSL module basics" chapter.
1. Change User ID
Changes the default User ID.
(maximum 17 alphanumeric characters), and then press
ENTER.
2. Change User Password
Changes the default User password. Type the new password
(maximum 17 alphanumeric characters), and then press
ENTER. Retype the new password, and then press ENTER.
3. Change NetMan Password
Changes the default Network Administrator password. Type
the new password (maximum 17 alphanumeric characters),
and then press ENTER. Retype the User password, and then
press ENTER.
For more information on changing the User ID or password,
see the "Administration" chapter.
- 59 - PARTNER ACS 1600 DSL module User Guide
For more information on
Type the new User ID
Advertisement
Table of Contents
