Configure Dlcis (Frame Relay) - Avaya PARTNER 1600 DSL MODULE User Manual

Avaya, Inc.
D. Enable/Disable SDSL Debug Messages
Enables and disables the display of SDSL debugging
messages. Select to enable. Select a second time to
disable.
Y. Enable/Disable Sync Msgs
Enables and disables the display of configuration
synchronization messages. Select to enable. Select a
second time to disable.
P. Preactivation Debug Mode
Enables and
messages. Select to enable. Select a second time to
disable.
Select your choice.

3. Configure DLCIS (Frame Relay)

Displays the FR DLCI Config Menu, which contains the
following commands to set the current DLCI value.
1. Add New DLCI
Type the DLCI number, press ENTER, and then
choose a command from the FR Encapsulation
Configuration submenu.
1. RAW (No Encapsulation)
2. Proprietary Voice DLCI
3. RFC 1490
4. ATM RFC 1483 (Tunneling)
Select your choice, and then choose a command from
the FR DLCI Options submenu.
1. Configure Transmit CIR
Follow the on-screen messages to enter the
following information.
Questions below may or not display, depending
on the options that you select.
The PARTNER ACS 1600 DSL module displays
a default or last-used value in parentheses to
the left of the command prompt. To accept this
value, press ENTER.
- 48 - PARTNER ACS 1600 DSL module User Guide
disables the preactivation
Transmit Committed Information Rate
(CIR)
Committed burst size (Bc)
Circuit Throughput
Excess burst size (Be)
debug