Voicepath Configure; Set Voice Gateway; Set Jitter Delay - Avaya PARTNER 1600 DSL MODULE User Manual

P. VoicePath
Configure
Avaya, Inc.
DLCI number and encapsulation type to RFC1490 or
RFC1483. .
parameters, it finds the first available slot, interface,
port and connection.
set nat <on or off> (slot) (interface) (port) – sets
NAT on or off. .
parameters, it finds the first available slot, interface and
port.
set dns server address <DSN server IPaddress> -
sets the DNS server IP address.
set system defaults – sets the system to the default
parameters.
show configuration
configuration.
show ip routes – displays the IP route table.
ping <IPaddress> (size of pings) (number of pings)
– pings an IP address.
Displays the Voice Configuration submenu, which contains
the following commands:
V. Set Voice Gateway
Displays the Voice Gateway Selection submenu, which
contains the following commands to set the voice gateway.
0. No Voice Gateway
1. MGCP 0.1/NCS 1.0
2. CopperCom
3. JetStream
4. TollBridge
Select your choice.
J. Set Jitter Delay
Sets the jitter delay, a value between 0 and 50 ms (default = 0
ms).
Jitter delay is defined by equation as:
Jitter Equation [CASZ97]2
Inter-arrival jitter is the difference in relative transit time for
two packets. It is the difference between the packet's RTP
time-stamp and the receiver's clock at the time of arrival of the
packet.
- 76 - PARTNER ACS 1600 DSL module User Guide
If you do not enter any optional
If you do not enter any optional
– displays the current