Table of Contents
Advertisement
Avaya, Inc.
T. Remove the Default Route
Deletes the default static route from the Route Table.
Type the IP address to remove, and then press
ENTER.
D. Display Route Table
Displays the following information about statically
configured routes and dynamically learned ones:
NETWORK
address.
NETMASK - IP subnet mask; number of bits
reserved for the host ID.
GATEWAY ADDRESS - IP address of
packets sent to destination.
interface - IP address of outgoing interface.
Metric - number of hops (routers) required to
reach the specified gateway.
Type – static or dynamic.
R. Enable/Disable RIP
Enables and disables the Routing Information Protocol (RIP).
RIP sends routing information from one router to adjacent
routers, dynamically "learning" network topology.
When you enable RIP, the PARTNER ACS 1600 DSL module
stores sent routing information in the Route Table. For more
information on the Route Table, see "Reports Menu" earlier in
this chapter.
V. Configure RIP Version by Port
Sets the RIP version for the selected port.
Type the number of the Interface, the port number, and then
select one of the following RIP Versions:
0. Disabled
1. Version 1 Broadcast
2. Version 2 Broadcast
3. Version 2 Multicast
P. Configure RIP Poisoned Reverse by Port
Enables and disables RIP Poisoned Reverse for the selected
interface.
Type the number of the Interface, and then enable or disable.
- 32 - PARTNER ACS 1600 DSL module User Guide
ADDRESS
-
destination
Advertisement
Table of Contents
