Configuring The Voice Path; Setting The Jitter Delay - Avaya PARTNER 1600 DSL MODULE User Manual

Configuring
the voice path
Avaya, Inc.
restarting the PARTNER ACS 1600 DSL module, see the
"Getting started" chapter.
After you define the voice PVCs and DLCIs, you need to
perform the following steps to configure the voice path:
Set the jitter delay
Set the SLIC control mode
Set the echo cancellation

Setting the jitter delay

When the jitter delay is set, the PARTNER ACS 1600 DSL
module holds the incoming packet data from the WAN voice
channel to allow for variance in packet arrival time. The time
that you set for the jitter delay depends on the data rate in use
– the lower the data rate, the higher the delay.
To set the jitter delay
1. On the Main Menu, select VoicePath Configure.
The Voice Configuration submenu displays.
*****************************************
* Voice Configuration
*****************************************
V. Set Voice Gateway
J. Set Jitter Delay
D. Display Jitter Delay
T. Set SLIC Control Mode
U. Set Compander Mode (u-Law, A-Law)
M. Set Debug Mode
E. Configure Echo Cancellation Default
Settings
2. Select Set Jitter Delay.
The following instructions display on-screen:
Enter number of ms to delay :
3. Type the number of ms to delay, and then press ENTER.
You must restart the PARTNER ACS 1600 DSL module
for any changes to take effect. For more information on
restarting the PARTNER ACS 1600 DSL module, see the
"Getting started" chapter.
- 124 - PARTNER ACS 1600 DSL module User Guide
*