Table of Contents
Advertisement
Your settings display in the Display Current Configuration
command in the Reports Menu. For more information, see
"Reports Menu" earlier in this chapter.
You must enable bridging both globally and by port number,
and then restart the PARTNER ACS 1600 DSL module for
any changes to take effect.
For more information on
restarting the PARTNER ACS 1600 DSL module, see the
"PARTNER ACS 1600 DSL module basics" chapter.
G. Enable/Disable Bridging Globally
Enables and disables bridging for all installed interfaces.
P. Enable/Disable Bridging by Port
Enables and disables bridging by port.
Type the number of the Interface to enable or disable, and
then press ENTER.
A. Configure Bridge Aging Timer
Sets the bridge database aging time, a value between 1-3,600
seconds (default = 300 seconds). Type the bridge aging time
value, and then press ENTER.
The PARTNER ACS 1600 DSL module displays a default or
last-used value in parentheses to the left of the command
prompt. To accept this value, press ENTER.
The time counts down in one-second intervals; at zero, the
entry deletes from the database.
T. Enable/Disable Spanning Tree Globally
Enables and disables the Spanning Tree protocol for all
installed interfaces.
O. Enable/Disable Spanning Tree by Port
Enables and disables the Spanning Tree protocol for the
selected Interface.
Type the number of the Interface, and then select enable or
disable.
R. Configure Spanning Tree Bridge Priority
Sets the Spanning Tree bridge priority, a value between 1-
65,565 (default = 32,768). Type the Spanning Tree bridge
priority value, and then press ENTER.
The PARTNER ACS 1600 DSL module displays a default or
last-used value in parentheses to the left of the command
prompt. To accept this value, press ENTER.
Avaya, Inc.
- 41 - PARTNER ACS 1600 DSL module User Guide
Advertisement
Table of Contents
