Display Route Table; Display Arp Table; Display Bridge Forwarding Database - Avaya PARTNER 1600 DSL MODULE User Manual

Avaya, Inc.
R. Display Route Table
Displays the following information about statically configured
routes and dynamically learned ones:
NETWORK ADDRESS - destination address.
NETMASK - IP subnet mask; number of bits
reserved for the host ID.
GATEWAY ADDRESS - IP address of packets sent
to destination.
interface - IP address of outgoing interface.
Metric - number of hops (routers) required to reach
the specified gateway.
Type – static or dynamic.
A. Display ARP Table
The Address Resolution Protocol (ARP) obtains the Ethernet
MAC address for a known IP address.
Displays the following information about mappings between
Ethernet Media Access Control (MAC) addresses (hardware
addresses) and IP addresses:
IP ADDRESS - IP address that corresponds to the
MAC address.
ETHERNET ADDRESS - Ethernet address of the
device; assigned by the manufacturer.
interface - the interface for the Ethernet address.
B. Display Bridge forwarding database
Displays the following information about mappings between
Ethernet addresses and devices connected to the LAN:
ETHERNET ADDRESS - Ethernet address of the
device; assigned by the manufacturer.
interface - the interface for the Ethernet address.
PORT - the port for the Ethernet interface.
TIMER - number of seconds until this entry deletes
from the database. The time counts down from the
Bridge database aging time value, in one-second
intervals; at zero, the entry deletes from the
database.
You must enable bridging for this table to display. For more
information on enabling bridging, see the "PARTNER ACS
1600 DSL module basics" chapter. For more information on
the maximum aging time value, see "Configure bridge" later in
this chapter.
- 28 - PARTNER ACS 1600 DSL module User Guide