Table of Contents
Advertisement
Page 10 - Subscribing
Subscribing
Introduction
For DECT handsets to be connected to a DECT system they have to go through a
process called 'subscription'.
Logging On:
The 20DT can subscribe to four DECT systems. However, it can only be logged onto
one of those systems at any one time.
Subscribing to a New System
Before a handset can subscribe the system manager must allow subscription. To do
this they need to known the handset's serial number. This is shown on a label covered
by the handset battery. Remove handset back cover and lift out battery unit to show
label. The serial number follows the characters SN:.
To log-on and make calls the following are required:
•
•
•
To subscribe to a new system:
1. Press MENU, then > until LOGIN appears and then press .
SELECT LOGIN appears
2. Press > until SUBSCRIPTION CREATE appears, then press .
3. Press > until required system SEARCH ID number appears.
•
4. When the required ID is shown, press .
5. CREATE SYSTEM 1 to 4 appears.
Press > until required SYSTEM number (1 to 4) appears.
6. AC: _ _ _ _ _ _ also appears. If required, enter an Account Code and/or press .
7. SUBSCRIPTION WAIT appears. If for some reason your handset cannot subscribe
it displays FAILED. Press
8. When successfully subscribed, your handset bleeps and INDeX XXXX is displayed
(where XXXX is your handset number).
38DHB0002UKCW - Issue 5 (12/00)
An extension number on the system (provided by your system manager).
The ID number of the DECT system.
An account code if necessary (provided by your system manager).
The handset displays the ID's of any systems in range. If there are several
systems locally, use < and > to display the different ID numbers found.
to try again from step 2 above or press MENU to stop.
INDeX DECT 20DT Handset User's Guide
Advertisement
Table of Contents
