Dial Mode - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Dial Mode

Dial Mode
Use this procedure to specify whether an incoming or outgoing tie trunk is
touch-tone or rotary.
Touch-tone cannot be programmed for incoming immediate signaling tie
trunks. Users of touch-tone single-line telephones cannot make calls by using
individual trunks programmed for rotary operation. The touch-tone signals
generated from the telephone while dialing are transmitted to the central office
at the same time the rotary signals are sent to the system. The central office
receives both signals and cannot process the call.
Summary: Dial Mode
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
7-6 Tie Trunks
System manager
All
Not required
Form 3c, Incoming Trunks: Tie
Rotary
Rotary, Touch-tone
Yes
Yes
To program a single line/trunk:
LinesTrunks TIE Lines
Dial line/trunk no.
Mode
Exit Exit
To program a block of lines/trunks:
LinesTrunks TIE Lines
block of lines Toggle LED On/Off
Exit
Inmode or Outmode
Enter or Delete
Inmode or Outmode
Exit
Entry
Exit
Select
Exit