Restore - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Restore

Restore
Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation
card is copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the
current set.
The processor module is replaced.
A System Erase (frigid start) has been performed.
The system software has been reinstalled.
The Inspect feature (Inspct or [PgDn]) is available to view the attributes of the
backup files on the memory card prior to initiating the restore procedure. The
attributes included on the Inspect screen are the filename, the time and date
of the file backup/update, the location of the system programming port, and
information about the system software release from which the backup was
made.
If any type of programming is taking place at another extension when you
begin the restore procedure, the restore is canceled and the number of the
busy extension appears on the screen. Repeat the restore procedure when
the busy extension becomes idle.
If a line is busy (incoming call or active call) when you begin the restore
procedure, the restore is canceled and the number of the active line appears
on the screen. Repeat the restore procedure when the line becomes idle.
See Table 22-3, "Memory Card Restore Error Messages" if the restore
procedure fails.
22-14 Memory Card