Copy Options For Lines/Trunks - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Copy Options for Lines/Trunks

Copy Options for Lines/Trunks
Use this procedure to copy options assigned to loop-start or ground-start
trunks, Tie trunks, or DID trunks. Note that many of these options apply to
Hybrid/PBX systems only. The following information is copied for each
line/trunk type:
Loop-Start or Ground-Start Trunks (including those emulated on T1
facilities). Toll type, signaling type, and trunk pool assignment
(Hybrid/PBX only.)
Tie Trunks. Direction, Tie trunk type, E&M signal, dial mode, dial tone,
answer supervision time, disconnect time, and trunk pool assignment
(Hybrid/PBX only).
DID Trunks (Hybrid/PBX only). Block assignment and disconnect
time.
To find out whether there is an optional feature assigned that you would like to
copy, use Inspct from the system programming console or [PgDn] on a PC.
NOTES:
1. You can copy options to a block of lines/trunks only if they are all the same
type (loop-start, ground-start, Tie, or DID). If you attempt to copy
assignments and there is mismatch in line/trunk type, information is copied
to that point only. You receive no error message.
2. If you are copying options to a block of lines/trunks, they must be
sequentially numbered.
If the block you are copying to includes an invalid line/trunk type, the
3.
copying process stops at the invalid type. Only the lines/trunks that were
copied to before the invalid type was found are copied successfully.
5-22 Lines and Trunks