Facility Restriction Level - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Facility Restriction Level

Facility Restriction Level
Use this procedure to assign a Facility Restriction Level (FRL) to each route.
The FRL ranges from 0 (least restrictive) to 6 (most restrictive) and is used to
restrict user access to the route. The FRL assigned to telephones and remote
access users is the opposite of the FRL assigned to routes, where 0 is the
most restrictive and 6 is the least restrictive.
NOTE:
Pool routes must be programmed before you assign Facility Restriction
Levels.
Facility Restriction Levels are assigned to Tables 1 through 18. Tables 17 and
18, the Default Toll and Default Local tables respectively, cannot be changed.
Summary: Facility Restriction Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
16-8 Automatic Route Selection
System manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and Special
Numbers Tables
3
0 to 6
No
No
Sub A FRL or More and Sub B FRL
Tables ARS
Dial table no. and pool route no.
restriction level
Enter
[F8] [F6] [F4] or [PgUp] and [F1]
pool route no. [F10]
[F5]
Enter
Exit Exit
Type table no. and
Type restriction level
Dial
[F10] [F5]