D-2. Programming Analog Multiline Telephones - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

General Feature Use and Telephone
Programming
Table D-2. Programming Analog Multiline Telephones
Step
Label the button.
1
Note: Skip this step if the
feature will not be programmed
onto a button.
Begin programming.
2
3 Select the feature.
End programming.
4
D-14 Programming Summary
Action
Remove the clear label cover from
the telephone by inserting the end
of a paper clip in the notch at the
top of the cover.
Write the feature name on the
card next to the button to be
programmed.
Replace the cover.
Slide the T/P switch on the side of
the telephone to P.
Press the button you labeled.
If you have a display, it shows the
name of the feature currently
programmed on the button. If no
feature is programmed, the
display indicates that the button is
blank.
Note: if the feature does not get
programmed onto a button, press
any line button. This does not
affect the button in any way.
Dial the programming code.
The feature is programmed.
Slide the T/P switch to the center
position.