Primary Operator Positions; Qcc Operator Position - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Primary Operator Positions

Primary Operator Positions
The primary operator position is the extension to which your call is directed
when 0 is dialed on a System Access button. The first extension jack on the
first MLX module in your system is assigned as the primary operator position.
If your system has QCC operator positions, this position must be changed
from the factory setting (DLC) to a QCC operator position. (The primary
operator extension cannot be changed from the first extension on the first
MLX module.)

QCC Operator Position

The QCC operator position is available only for Hybrid/PBX systems. The DLC
operator position is available in any mode and must be programmed if you
have Call Management Systems connected to any operator extension jacks.
QCC System Operator Positions.
This procedure applies to Hybrid/PBX systems only.
IMPORTANT:
If you want to add or remove QCC operator positions, the following
conditions apply:
If other QCC positions remain in your system, the primary QCC
operator position cannot be removed.
When QCC operator positions are added, the primary QCC
operator position should be the first one added.
If QCC operator positions are being removed, the primary QCC
operator position must be the last one removed.
System Operator Positions 4-3