Terminal Equipment Identifier - AT&T MERLIN LEGEND Release 3.0 Programming Summary Manual

Terminal Equipment Identifier

Terminal Equipment Identifier
Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
CAUTION:
The value of the TEI rarely has to be changed. Check with your
authorized support representative before changing this value.
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
All
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
0
0 to 63
No
No
LinesTrunks PRI
Drop Dial new ID no.
Enter
Exit
[F4] [F6] [F6]
Type new ID no.
Protocol TEI
Enter
[F2] Type slot no.
[F10] [F5] [F5]
PRI Facilities 9-15
Dial slot no.
Exit Exit
[F10] [Alt] + [P]
[F5]